Kambrook Vacuum Cleaner KVC30 User Manual

Kambrook 461 Plummer Street, Port Melbourne 3207, Australia  
Customer Service Line (free call) 1800 800 634 Customer Service Fax 1800 621 337  
Kambrook New Zealand, Private Bag 94411, Greenmount, Auckland, New Zealand  
Customer Service Line/Spare Parts 09 271 3980 Customer Service Fax 0800 288 513  
JaguarVacuum  
Cleaner  
Due to continual improvement in design or otherwise, the product you purchase may differ slightly from the one illustrated in this book. Issue 1/06  
 
KVC30  
Issue 1/06  
To retract the cord push down on the  
‘cord rewind’ pedal.  
The dust bag indicator window will  
gradually turn red as the bag fills up and  
when the dust bag indicator displays ‘red’  
it is time to change the dust bag.  
When vacuuming fine dust particles, the  
fine dust particles can clog the pores of  
the dust bag and the dust bag indicator  
will indicate full. If this happens the bag  
could appear relatively empty, however  
the bag will still need to be changed to  
avoid strain on the motor.  
UsingYour Kambrook Jaguar  
Vacuum Cleaner  
Remove all packaging from the unit, hose  
and other accessories; ensure that you  
have removed all of the accessories before  
discarding the packaging.  
IMPORTANT: HOLD THE PLUG END  
WHEN RETRACTING THE CORD TO  
PREVENT IT FROM STRIKINGYOU OR  
THEVACUUM.  
Always switch appliance off, then switch  
off at the power outlet and unplug the  
appliance prior to replacing dust bags or  
filters.  
ALWAYS ENSURETHATTHE  
DUST BAG ANDTHE MOTOR  
PROTECTION FILTER ARE  
CORRECTLY FITTED. NEVER  
OPERATE WITHOUTTHE DUST  
BAG AND FILTERS IN PLACE.  
Ensure that the dust bag and filters are  
correctly fitted.  
NOTE:The bag compartment lid may not close if  
the bag is not correctly fitted.  
To remove the dust bag, ensure the unit is  
down on its wheels, remove the crush  
proof hose and push the ‘Dust bag  
compartment lid release lever’ underneath  
the handle. Once the lid has released, pull  
the top cover back.  
Locate the crush proof hose and push the  
connection point into the hose inlet  
connection on the top of the unit, until a  
“click” sound is heard.  
IMPORTANT: DO NOT USE THE  
UNIT WITHOUT A DUST BAG IN  
PLACE  
Replacing filters  
Variable Power Control  
Connect the wide end of the metal wand  
to the hose end, and push together firmly.  
Filters must be cleaned from time to time  
to remove the fine dust particles that have  
been collected.This can be done by  
shaking them; however after  
approximately 5 dustbag changes the  
filters should be replaced.  
The variable power control slide switch is  
located on the top of the vacuum cleaner.  
Slide the control to the rear for maximum  
power for vacuuming hard floor and  
carpet surfaces. Slide the control to the  
To remove the bag, grasp the top of dust  
bag and pull out. If you are using the cloth  
bag dispose the dust in a rubbish bin. If  
you are using a paper dust bag you can  
dispose the bag with its contents in the  
rubbish bin.  
Fit the floor tool to the narrow end of  
the wand/s and push together firmly.  
Fully extend the power cord by pulling  
the power plug (situated at the rear of the front at the minimum power level when  
unit) out from the unit, until the yellow  
tape on the cord is shown.  
using the crevice and brush tools.  
Motor protection filter  
The motor protection filter must always  
be in place when operating the vacuum  
otherwise damage to the motor may  
occur  
Crevice and brush tool accessories  
To place a new dust bag, take a fresh dust  
bag and with the arrow (printed on the  
material section of the dust bag) pointing  
down slide the material down into the  
dust bag holder, until it comes in contact  
with the bottom of the holder.  
The crevice tool is ideal for vacuuming  
ENSURETHATYOU DO NOT  
OVER EXTENDTHE POWER  
CORD – DO NOT EXTEND PAST  
THE RED WARNINGTAPE ON  
THE CORD  
hard to reach places such as the edges  
along skirting boards.  
The brush tools can be used to vacuum  
delicate surfaces and areas such as shelves  
and venetian blinds.  
To replace the motor protection filter –  
Remove the dustbag or pull the bag  
forward.The motor protection filter is  
located at the rear, right hand side of this  
inner chamber. Pull the plastic filter holder  
upward to remove.  
Plug into a 230/240v power point and  
switch the power on.  
Set the variable speed control between  
minimum and medium power when using  
the tool accessories.  
To commence vacuuming push down on  
the on/off foot pedal, at the top, rear of  
the unit.  
Filter holder  
Turn off the vacuum cleaner when  
changing any attachments.  
Dust bag holder  
When vacuuming is complete, push down  
on the ‘on/off’ pedal to switch off.Turn  
the power off at the outlet and then  
remove the power cord from the power  
outlet (when removing plug from the  
power outlet grasp the plug not the cord).  
Dust bag indicator and changing the  
dust bag  
You have the option of using a Cloth bag  
or a paper dust bag.  
Filter holder  
Removable filter  
HINT: once the bag is inserted ‘puff-out’ the bag as  
much as possible to ensure the full capacity of the  
bag can be taken up.  
The dust bag should be changed when full.  
4
5
 
KAMBROOK  
2YEAR REPAIR  
WARRANTY  
Care and Maintenance  
Always switch appliance off, then switch  
off at the power outlet and then unplug  
the appliance prior cleaning or replacing  
either filter.  
KAMBROOK warrants the purchaser  
against defects in workmanship and material, accessories only the defective accessory  
If the product includes one or a number of  
for a period of 2 years from the date  
of purchase (3 months commercial use).  
or product will be replaced.  
To clean the outside of the unit, wipe the  
exterior with a soft, damp cloth. Never  
use an abrasive cleaner.  
In Australia, this KAMBROOK Guarantee  
is additional to the conditions and  
guarantees which are mandatory as  
implied by the Trade Practices Act 1974  
and State Territory legislation.  
Guarantee and purchase receipt for this  
product are to be retained as proof  
of purchase and must be presented  
if making a claim under the terms of the  
KAMBROOK guarantee.  
Check and replace both the motor  
protection and dust filters on a regular  
basis.  
For service, spare parts or product  
information in Australia, please call  
KAMBROOK on the customer Service  
Line (free call) 1800 800 634.  
KAMBROOK reserves the right to repair  
the appliance within the warranty period.  
Warranty does not apply to any defect,  
deterioration, loss or injury or damage  
occasioned by, or as a result of the misuse  
or abuse, negligent handling or if the product  
has not been used in accordance with the  
instructions. Items subject to wear and  
tear, such as filters, bags, accessories and  
drive belts, are not covered by this  
warranty.The guarantee excludes  
For service, spare parts or product  
information in New Zealand,  
please call KAMBROOK New Zealand,  
Greenmount, Auckland Phone 09 271 3980  
Fax 0800 288 513. For spare parts phone  
09 271 3980.  
If claiming under this guarantee the product  
must be returned to freight prepaid.  
breakages and consumables.  
This warranty is void if there is evidence  
of the product being tampered with by  
unauthorised persons.  
YOUR PURCHASE RECORD (Please complete)  
Attach a copy of  
purchase receipt here.  
DATE OF PURCHASE___________________________
MODEL NUMBER _____________________________
SERIAL NUMBER (If applicable) ___________________
Please don’t return purchase record  
unless you are making a claim  
PURCHASED FROM ___________________________
6
 

Init TV Video Accessories NT SWM1B User Manual
Insignia GPS Receiver NS NAV01 User Manual
JVC Car Video System TM 910SU User Manual
Karcher Carpet Cleaner RM 69 ASF User Manual
Kawasaki Cordless Saw 840184 User Manual
Kawasaki Motorcycle FR600V User Manual
Kenwood Speaker KFC XW1222D User Manual
KitchenAid Refrigerator 2308307 User Manual
Knoll Systems Projection Television HD177 User Manual
Kodak Ventilation Hood J 314 User Manual